The two new products have been added to my store in the past week!
DOT (aka Dongle Organizing Toolbox) is an adorable little container for protecting a security key (dongle) or a flash drive as well as storing blade holders and blades for a range of cutters!
Read more about DOT here: DOT
Also, I’m very pleased to announce that I’m now selling Make-The-Cut! A plug-in was released last week and MTC now cuts directly to a Klic-N-Kut (all models) and offers the following advantages over KNK Studio only:
Further, you can now choose between Make the Cut and Klic-N-Kut Studio when ordering a new Groove-E! The Maxx models will continue to automatically be sold with KNK Studio, but for the low cost of MTC ($58.36), you may wish to add it on!
Note that owners of certain older KNK models may need to purchase serial plus serial/USB converter cables for communication from MTC to their cutters. Email me at email@example.com and I can help you determine if that will be necessary prior to purchase.
You can download and install the trial and then, if you like it, buy it from my store. Here’s the link to get the latest trial that has the KNK Plug-in
To learn where images will cut, check out my videos here:
and then you can start checking out some of the free software tutorials at these sites:
Again, if you decide you like it, then I sell the registration above. Thanks for posting!
Hi Sandy… I have been looking at MTC and was wondering whether this would be an easier program to operate than the KNK studio maxx… admittedly… I have not yet mastered the design part of using the KNK and havent really used my machine – I WANT TO START USING IT NOW… do you think the MTC will make things easier for me…
I look forward to hearing from you soon
kind regards and thanks