Page 27 - Orignal Klic-N-Kuts with MTC User Manual
P. 27
Landscape mode - just remember to place your material on the mat in the correct orientation for feeding
into the KNK.
The origin is still set using the blade tip. Go Offline, press the Menu button one time, and then press the
Origin button. Direct the blade holder to the bottom right corner of your material (see below).
WYSIWYG– Portrait Mode
Feed the mat this direction into the KNK
Indicates
Portrait
mode
Origin set here
Location of shapes on the screen Where shapes are drawn or cut on material
WYSIWYG – Landscape Mode
Feed the mat this direction into the KNK
Indicates Landscape mode
Origin set here
Location of shapes on the screen Where shapes are drawn or cut on material
Print and Cut
This is the mode recommended when you want to print images on your printer and then have the KNK cut
them out.
It is similar to WYSIWYG because shapes will be cut where they are located on the Virtual Mat. However,
in the Print and Cut process, three printed registration marks are printed along with your images. The test
pen is used to set each mark and the KNK will then cut out your shapes based on triangulation. This is far
27
