Page 11 - Orignal Klic-N-Kuts with MTC User Manual

(1) Remove blade cap and insert non-sharp end of blade into the silver blade holder shaft.

(2) Carefully slip the blade holder shroud over the sharp blade tip and screw the shaft clockwise into the
shroud.

(3) Unscrew the adjustment ring, as necessary, so that, as the shaft is rotated, the blade tip will begin to
protrude from the bottom.
(4) Once the appropriate blade length is exposed, tighten the adjustment ring.

(B) Silver Blade Holder:

 The blade must be carefully inserted into the blade holder. Do this over a soft surface (e.g. over a hand
towel). It’s important to protect the fragile blade! To install, follow the numbered steps as shown:

Step 1. Push
1. Unscrew cap and inwards so that
set aside. blade can be
inserted.

3. Replace cap and screw onto main section
only until blade exposure matches the
thickness of the material being cut. 2. Gently insert non-sharp end into holder. An
internal magnet will pull the blade inwards.

 The silver blade holder may need adjusting so that the tip of the blade can be just above the cutting surface.
The widest part of the blade holder, referred to as the flange, is initially positioned too low and will then force
the blade holder to sit too high in the grip on the KNK. Simply unscrew the top of the blade holder and move
the flange upwards by unscrewing, and then tighten the top down onto the flange. Note, that it is then NOT
necessary to push the blade holder all the way down. The blade holder should be positioned in the grip so

11