Page 8 - Klic-N-Kut User Manual

1. Introduction to Your KNK

1.01 Unpacking

 Verify that you have received all contents. There is a checklist below. Please notify your KNK supplier
immediately if anything is missing.
 Remove all foam pieces and cut the white zip ties carefully before turning on the KNK. Do not inadvertently
cut the black belt that is positioned behind the zip ties.
 Use the enclosed test pen as you experiment and become familiar with operating the KNK. Place scrap
paper on the mat and simply draw shapes rather than cut them. This will prevent possible damage to the
blade, mat, and cutting strip as you learn where shapes will cut and the basic operating procedures.
 Do not unplug the USB cable from your computer or from the cutter unless you first turn off the cutter. Doing
so can cause power fluctuations that, in turn, can damage the cutter.
 Always turn off the KNK when not in use. Leaving the cutter turned on for extended periods of time can
possibly damage the machine.

1.02 Contents
 Your KNK package comes with the following:
KNK digital die cutter Blade Holder
Make The Cut (MTC) Activation Pin 45˚blade (red cap) with spring
Cutting Mat 60˚blade (blue cap) with spring
Spray adhesive USB and Serial cables
Test Pen with 2 inserts and a spring Power cord
Bolt-on flatbed tables USB – Blue Tooth adaptor
Screwdriver and screws for attaching tables Bonus package

1.03 Items to Note (Please Read!)

 Blades: The blades used by cutters are extremely fragile. Avoid dropping or bumping the blades against
hard surfaces. When not in use, retract the blade into the blade holder or remove and cover the sharp end
with the soft plastic cap. Keep these small blades and the springs in a safe place.
 Warranty: The one year warranty covers Manufacturer’s Defect only and does not include normal wear and
tear. If warranty work is required, the owner is responsible for shipping costs to and from KNK USA. If a
KNK is damaged during shipment, then your dealer should be notified as soon as possible. If damages are
reported later than three weeks after delivery, then it will be the responsibility of the owner to ship the
damaged KNK back to KNK USA for repair.
 KNK owners outside the USA should contact their KNK dealer for procedures regarding warranty work or
shipping damage.

 Transporting: When transporting the cutter, move the pinch wheel levers into the upward position. Remove
the accessories from the KNK and place in a separate bag. We also recommend retaining the original boxes
with the foam inserts in case you ever need to ship your KNK.

 Additionally:
 DO NOT touch or jam the plotter’s track while it is operating. If the cutter is damaged, it is the owner’s
responsibility.

 DO NOT shake the cutter while it is operating.
 DO NOT cut any materials that have staples or other embellishments attached.

8