Page 206 - Klic-N-Kut User Manual

9.04 PNC Procedure Part 2: Aligning and Calibrating

Aligning the Laser with the Registration Marks IMPORTANT: Set Us and Cut Speeds to 200

 Click on the Cut Project With icon to go to the cut window. If you haven’t yet performed a test cut, do so
now using either the Knife Point or WYSIWYG setting. Perform the test cut in a location that won’t be part
of your final cut or use a scrap of the same material you are cutting.
 After the test cut is successful, move the laser light until it is directly over the lower right corner of the
printout, as indicated in Section 9.03. Set the origin.
 Under Cut Type, select Print and Cut:

 Click on Start and the following window will open. Check Fixed Length and enter 11.0”, assuming you set
your Virtual Mat to be 11” in width. Then click on Begin.

 The laser (or alignment pin) should automatically move to within a very short distance of the first registration
mark. The following window will open:

This dot will be
Select step size for each
flashing red arrow key movement

Click on arrows to move the laser
light or pin. Or use the arrows on the
keyboard.

Click on Center button (or press Enter key on
keyboard) after you have moved the laser (or pin)
to the exact corner of the reg mark

 Make sure the laser (or pin) has moved to within an inch or less of the registration mark indicated by the
flashing red dot shown above. Note: this will be the upper right reg mark as you are facing the KNK since
your printed arrow should be pointing to the right (as shown on the previous page). If not, you’ll want to
review the steps you’ve used so far to make sure you have all of the same settings shown and you have
your printout on the mat in the same orientation as shown previously.
206