Page 205 - Klic-N-Kut User Manual

Click here to print.

Check this preview carefully.

Do you see all four
registration marks? (red
arrows point out the 4 reg
marks)

Will you be getting what you
need printed?

(Note that the Wireframe
option was turned off for this
screen shot so that the
image could more clearly be
seen in this tutorial).

 Always make sure you can see those registration marks before continuing since they are an integral part of
the PNC process. If your print preview matches the one above and you see the four marks, click on the
Print button. Also verify that what is being printed is what you need. For example, you may have added an
extra shape to be cut, but you do not want it showing up in the printout. This is where you will want to use
the Layers feature to control what will be printed, as well as what will be cut later.

 You may want to print several (4 or 5) copies since you will want to repeat this process several times in
order to get your calibration settings perfect.
 After printing, place the printout onto the mat, in the same orientation you see in the main window and insert
the mat into the KNK. As you are facing the KNK, the printout should be on the mat in a portrait orientation
with the arrow pointing towards the right end cap:

Feed the mat this
direction into the
KNK

Place your printout
on the cutting mat in
this orientation.
Set the origin in the bottom
right corner of the printout,
using the laser.

205