Page 194 - Orignal Klic-N-Kuts with MTC User Manual

 The test pen should automatically move to within a very short distance of the first registration mark. The
following window will open:
This dot will be
flashing red Select step size for each
arrow key movement

Click on arrows to move the test
pen. Or use the arrows on the
keyboard.

Click on Center button (or press Enter key on
keyboard) after you have moved the test pen nib
to the exact corner of the reg mark

 Make sure the test pen has moved to within an inch or less of the registration mark indicated by the flashing
red dot shown above. Note: this will be the upper right reg mark as you are facing the KNK since your
printed arrow should be pointing to the right (as shown on the previous page). If not, you’ll want to review
the steps you’ve used so far to make sure you have all of the same settings shown and you have your
printout on the mat in the same orientation as shown previously.
 The next step is to move the test pen so that it is precisely at the corner of the printed registration mark. Use
the arrow keys in the software or use the arrow keys on your keyboard. When the test pen nib is precisely
on the printed dot, click on the center target button on the screen (or press the Enter key on your keyboard).
 The test pen will now move to the vicinity of the next registration mark and the flashing red light in the
software moves to the same relative point:

This dot will now be flashing red

Again, click on these arrows or your
keyboard arrows until test pen nib is on
the reg mark corner.

Once the test pen is centered on
the reg mark dot, click on Next.

 Repeat the process with the final reg mark:

194