Page 34 - Klic-N-Kut User Manual

Feed the mat this
direction into the KNK

WYSIWYG

 This is the mode recommended when you need to cut shapes in very specific locations on your material
(such as the center front of a greeting card).
 Create a virtual mat that matches the material dimensions. For example, if you are cutting from an 8.5” x 11”
sheet of cardstock, then create a Virtual Mat with those same dimensions. You can use either Portrait or
Landscape mode - just remember to place your material on the mat in the correct orientation for feeding
into the KNK.

 The origin is set using the laser light, not the blade tip. In Online mode, press the Origin button to turn on
the laser. Go Offline and direct the red dot of the laser light to the lower right corner of your material (see
below). Note that if you need absolute precision for the location of your cuts, it will be necessary to calibrate
the Laser Offset, which is covered in Chapter 9.

 WYSIWYG– Portrait Mode
Feed the mat this direction into the KNK
Indicates
Portrait
mode

Origin set
here using
laser light

Location of shapes on the screen Where shapes are drawn or cut on material

34