Page 33 - Klic-N-Kut User Manual

 Knife Point – Portrait Mode

Feed the mat this direction into the KNK
Indicates
Portrait
mode

Origin set
here using
blade tip

Location of shapes on the screen Where shapes are drawn or cut on material

 Knife Point – Landscape Mode
Feed the mat this direction into the KNK

Indicates Landscape mode

Origin set
here using
blade tip

Location of shapes on the screen Where shapes are drawn or cut on material

 If you plan to use scraps of materials for cutting shapes, you will want to use the Knife Point mode:

 Place several scraps (large enough for the shape on your screen) on your mat in different locations, as
shown in the following diagram.
 Insert the mat into the KNK and then set the origin at the lower right corner of one of the scraps and cut
the currently selected shape.
 Move the blade holder to the bottom right corner of the next scrap and set the origin there and cut the
same shape (or another shape, depending on what you have on your virtual mat). Repeat for other
scraps. Note the red “X”’s indicate where the origin would be set so as to not cut off the scrap:

33