Page 32 - ACS 24-UHF Eagle with MTC User Manual

Enter 8.0 and press H will automatically change
the Enter key to 8.0, as well, if Aspect

Ratio is locked

To calibrate in inches Make sure this is locked

Enter 200mm

To calibrate in metric

After pressing the Enter key, both W: and H: will be converted to inches, but you can use a

metric ruler to measure your drawn square and enter the results in mm, as shown below.

 Set the origin on your paper. Make sure you have plenty of room to draw the square. Click on the Cut
Project With icon (or go to Cut Project With>Klic-N-Kut Series):

Cut Project With icon

H

W

 Have the ACS-24HUF draw the square. Then take a ruler and carefully measure the two sides.
 Click on the Cut Project With icon again, and click on a tiny wrench icon next to the Klic-N-Kut Model menu:

Click on small wrench icon here

 A window will open. Click on the Resolution tab and then click on another small wrench icon:

32