Page 13 - ACS 24-UHF Eagle with MTC User Manual

First, lay a soft towel down. Next, gently turn your
ACS-24UHF upside down to expose the bottom
panel. Unscrew the screws along one side of the
bottom panel.

Next, slip one of the tables into place and put
the bottom screws back in. Once the screws
are tightened, turn the ACS-24UHF back over,
where the cutter is facing up.

Insert 5 of the 10 screws that were packaged
inside the box with the tables. Be sure to keep
the five screws relatively loose until all have been
inserted. Then tighten down but not too tight or
you will risk stripping the threads.

Repeat this for the other side of the ACS-24UHF.

1.09 Installation of your ACS Cutter and Software

Registering Make The Cut IMPORTANT: Please read this section!!!

 If you received a 14 digit Activation Pin with your purchase of Make The Cut (MTC) software, this is NOT the
code you use in the software. This pin must first be registered! If, instead you already have a much longer
number beginning with “MTC”, then use that number in the software to register and skip the next two steps.

 Go to the following link to register your Activation Pin:
https://www.make-the-cut.com/register.aspx
 Complete the form using the Activation Pin. Carefully enter your email address because you might need to
request your registration number again in the future and it will be sent to that address. Upon completing the
form, a registration number will be provided. This is your permanent registration number for the computers
you own. You can leave this window open until you get MTC installed or you can verify that the number has
also been emailed to you.

13