Page 222 - Orignal Klic-N-Kuts with MTC User Manual

 You may need to change the power settings for the USB ports. To do this, go to Windows Control
Panel>System and Security>Power Options. Click on Change Plan Settings and then Change
Advanced Power Settings. In the Advance Power Settings window, click on the + next to USB
Settings. Make sure the USB Selective suspend setting is Disabled.

 If the KNK still becomes disconnected, make sure you are using the latest plugin. These are available at
http://knkusa.com/resources/

 Try applying Flatten Paths before sending to the cut window. Select your shapes, click on the wrench
icon at the bottom of the screen, and select Flatten Paths from the pop up menu.

 Try changing the COM Port that has been assigned.
____________________

Operating Issues

My mat is rotating when the KNK starts to cut!

 Make sure the rollers are on the mat and also over the gridded part of the shaft beneath. Tighten the
pinch rollers, as necessary, in the back. If the problem continues, try a thicker mat such as the
Maxx/Groove mat sold at www.knkusa.com.
____________________

At low pressures the blade doesn’t touch the surface.
 That is correct. Simply increase the pressure, as necessary, to get a good test cut.
____________________

The KNK stops cutting when the screen saver comes on.

 This can happen with some computers. Turn off the screen saver before cutting.
____________________

Cutting/Drawing Issues

I am getting large diagonal lines sliced through all of my cuts.
 Your Make The Cut software is still in trial mode. You need to register your copy of MTC using the
activation pin that came on the software CD. Here is the link: https://www.make-the-
cut.com/Register.aspx
____________________

My shapes are drawing off the material. What am I doing wrong?
 Check whether your Virtual Mat is in Portrait or Landscape mode. This will change whether your
image appears the same way you see it on the screen or rotated 90 degrees relative to the screen.
Refer to Section 2.07.
____________________

When drawing with the test pen, I have extra lines being drawn.

 Make sure you raise the pen in the blade holder seat on the KNK before tightening the front screw. The
blade holder seat needs to be able to drop the pen down when it reaches the spot to draw the shape.

222