Page 15 - KNK Maxx Groove-e with MTC User Manual

Watch this video!
BUT remember, it
works a bit
differently on your
KNK!

 In the Bridge program, after selecting the tty listing under COM 1, be sure to click on Save at the bottom of
that window:

Select the tty
connection here.

Then, click on Save.

 Go to your Applications folder and hold the Ctrl key while clicking on the MTC icon. Choose Open from
the drop-down menu.

 Enter the registration number you received when you registered the software.
 If you lose your registration number and you need to install MTC onto another computer, please go to the
following link to have it emailed to you:

http://make-the-cut.com/LostRegKey.aspx
 You may now skip to Section 1.11.

1.10 Connecting the KNK to Your Computer under Windows

 Place your KNK on a sturdy horizontal surface. If you have not yet done so, attach the bolt-on tables to the
cutter (refer to the instructions in Section 1.08.) If you are not going to use the tables, then be sure to allow
enough free room in both the front and the back for the mat to extend during cutting.
 Connect the power cord to the left side of the cutter and plug into a wall outlet or power strip. Turn on the
power using the power switch on the left side. The yellow LED display should come on and the cutter will
initialize (carriage will move to the far right side of the cutter).
 Connect your KNK to your computer using either of the following:

 USB Connection: Turn off the cutter and connect the USB cable to the right side of the cutter and into
an available USB port on your computer. Turn on the cutter. The Windows Hardware Manager will
15