Page 13 - KNK Maxx Groove-e with MTC User Manual

 Alternatively, silicon spray or silicon grease can be applied to the rubber wheels and then the adhesive from
the mat will not stick to the rubber. Do not spray the wheels directly; instead spray a clean rag or a paper
towel and then apply the wet paper towel to the wheels, or use a cotton swab to apply the silicon to the
wheels.

1.08 Attaching your KNK Bolt-On Tables

 It is strongly advisable that you attach the included bolt-on tables. They do not require any table support
beneath, thus can extend out over the front or back of a desk. The benefit is that these tables support the
cutting mat and prevent bowing in the middle. Additionally, the material being cut will be less likely to come
unstuck from the mat.
 The installation of the front and rear tables on your KNK is best done with two people. Each box contains 2
identical tables (front and rear) and a supply of screws.

First, lay a soft towel down. Next, gently turn your
KNK upside down to expose the bottom panel.
Unscrew the screws along one side of the bottom
panel.

Next, slip one of the tables into place and put
the bottom screws back in. Once the screws
are tightened, turn your KNK back over, where
the cutter is facing up.

Insert 4 of the screws (5 on the 24” Maxx) that
were packaged inside the box with the tables. Be
sure to keep the screws relatively loose until all
have been inserted. Then tighten down but not
too tight or you will risk stripping the threads.

Repeat this for the other side of your KNK.

13