Page 199 - ACS 24-UHF Eagle with MTC User Manual

This dot will be
Select step size for each
flashing red arrow key movement

Click on arrows to move the laser
light or pin. Or use the arrows on the
keyboard.

Click on Center button (or press Enter key on
keyboard) after you have moved the laser (or pin)
to the corner on the reg mark

 Make sure the laser has moved to within an inch or less of the registration mark indicated by the flashing red
dot shown above. Note: this will be the upper right reg mark as you are facing the ACS-24UHF since your
printed arrow should be pointing to the right (as shown on the previous page). If not, you’ll want to review
the steps you’ve used so far to make sure you have all of the same settings shown and you have your
printout on the mat in the same orientation as shown previously.

 The next step is to move the laser dot so that it is precisely at the corner of the printed registration mark.
Use the arrow keys in the software or use the arrow keys on your keyboard. You will notice that the intensity
of the laser light will change when it is on top of the printed black lines. This can be very useful! When the
laser light is precisely on the printed dot, click on the center target button on the screen (or press the Enter
key on your keyboard).

 The laser will move to the vicinity of the next registration mark and the flashing red light in the software
moves to the same relative point:

This dot will now be flashing red

Again, click on these arrows or your
keyboard arrows until laser dot is on the
reg mark corner.

Once the light is centered on the
reg mark dot, click on Next.

 Repeat the process with the final reg mark:

199
Click on Next after you
have moved the laser to
the corner on the reg mark