Page 198 - KNK Maxx Groove-e with MTC User Manual

This dot will be
Select step size for each
flashing red arrow key movement

Click on arrows to move the laser
light or pin. Or use the arrows on the
keyboard.

Click on Center button (or press Enter key on
keyboard) after you have moved the laser (or pin)
to the exact corner of the reg mark

 Make sure the laser (or pin) has moved to within an inch or less of the registration mark indicated by the
flashing red dot shown above. Note: this will be the upper right reg mark as you are facing the KNK since
your printed arrow should be pointing to the right (as shown on the previous page). If not, you’ll want to
review the steps you’ve used so far to make sure you have all of the same settings shown and you have
your printout on the mat in the same orientation as shown previously.

 The next step is to move the laser dot (or pin) so that it is precisely at the corner of the printed registration
mark. Use the arrow keys in the software or use the arrow keys on your keyboard. You will notice that the
intensity of the laser light will change when it is on top of the printed black lines. This can be very useful!
When the laser light (or pin) is precisely on the printed dot, click on the center target button on the screen
(or press the Enter key on your keyboard).

 The laser light /pin will move to the vicinity of the next registration mark and the flashing red light in the
software moves to the same relative point:

This dot will now be flashing red

Again, click on these arrows or your
keyboard arrows until laser/pin is on the
reg mark corner.

Once the light/pin is centered on
the reg mark dot, click on Next.

 Repeat the process with the final reg mark:

198