Page 10 - KNK Maxx Groove-e with MTC User Manual

Laser Mode Display

Step 3: In Offline Mode, press Press the Origin button to
the Menu button. turn the laser light on. You
will see a red light appear
The Laser display will show below blade carriage. Also,
and the laser can be activated. the cutter will change to
Online mode. To turn off the
laser, repeat Steps 2 and 3
and then press the Origin
button again.

Setting Display
Us = Traverse speed (movement of carriage
when head is up)
Br = Baud rate (USB: 57600, Serial: 9600)

Step 4: In Online Mode, press Increases/Decreases
the Menu button. Traverse Velocity (Up
Speed). Set to 200 if
Experiment with the “+” and “-“ doing PNC applications
buttons for the Traverse
Velocity. Change the Baud
Rate based on the connection
you are using. Increases/Decreases
Baud Rate: USB:
57600
Serial: 9600
Set Per Display
Xp = Calibration of X scale
Yp = Calibration of Y scale

Step 5: In Online Mode, press
the Menu button twice. Do not change these values.
Instead, it is recommended
Press again to turn off the that calibration of your KNK
Menu function. be done from within the
software. Refer to Section
2.10.

Pause Display

v = cutting velocity, mm/sec

f = cutting force (scaled from 1 to 160)

As shown above, use the “+”
and “-“ buttons to change the
Press the Pause button during cutting velocity or cutting force
the cut and the cutter will and press Pause again to
immediate stop cutting. resume the cut.
…OR…
Turn off the cutter to abort the
At the end of a cut, the Repeat cut.
button can be pressed, in
Offline Mode, to activate the
same cut again.

10