Please fill all required fields
    Intermediate Reg Mark Location Calculator for SCAL
    Units: Millimeters (except for Reg Mark Size and Offset, as shown)      
    Input Project CUT Layer Size and Location   Input Reg Mark Settings (Cutter>Cutter Settings)
    Project Top Left Corner (mm) X:   Reg Mark Size (cm) :  
    Project Top Left Corner (mm) Y:   Reg Mark Thickness (mm) :  
              Reg Mark Offset (cm) :  
    Width of Project (mm) W:          
    Height of Project (mm) H:          
                     
    Calculated Results  
    Top Left - X =       Top Right - X =    
    Top Left - Y =       Top Right - Y =    
                     
    Bottom Left - X =       Bottom Right - X =    
    Bottom Left - Y =       Bottom Right - Y =    
                     
    Vertical Spacing in Duplicate Window =        
                     
       
    		Powered By SpreadsheetConverter